Thanks to NT1K for awesome step by step instruction & DIY Project.
Photo by NT1K
Now that my station has grown, I have quite a bit of equipment that requires 12-14Vdc of power. In the past couple of years I decided to start using Anderson Power Poles. I decided to use them as it’s starting to be the standard of some organizations and It’s easy. My only complaint that I would have is that sometimes the connectors can loosen up and doesn’t require much force for them to come apart.
After completely soldering the links and installing the other end, I wrapped the positive side in plastic. If I were to do this again, I would solder, install heat shrink tubing both leads and then itstall the other set of connectors.
Source